Show simple item record

dc.contributor.authorKhosravi, Sinaen
dc.date2010-08-31 10:03:42.167
dc.date.accessioned2010-08-31T19:13:06Z
dc.date.available2010-08-31T19:13:06Z
dc.date.issued2010-08-31T19:13:06Z
dc.identifier.urihttp://hdl.handle.net/1974/6005
dc.descriptionThesis (Master, Chemical Engineering) -- Queen's University, 2010-08-31 10:03:42.167en
dc.description.abstractLaser Transmission Welding (LTW) involves localized heating at the interface of two pieces of plastic (a laser transparent plastic and laser absorbing plastic) to be joined. It produces strong, hermetically sealed welds with minimal thermal and mechanical stress, no particulates and very little flash. An ideal transparent polymer for LTW must have: a low laser absorbance to avoid energy loss, a low level of laser scattering so it can provide a maximum energy flux at the weld interface and also have a high resistance to thermal degradation. The objective of the project was to analyze the effect of blend ratios of polybutylene terephthalate and polyethylene terephthalate (PBT/PET) on these laser welding characteristics. The blends were manufactured by DSM (Netherlands). They were characterized using Differential Scanning Calorimetry (DSC) and Thermal Gravimetry Analysis (TGA). The latter technique was used to estimate the order (n), activation energy (ΔH) and frequency factor (A’) of the degradation reaction of the polymer blends. The normalized power profile of the laser after passing through the transparent polymer was measured using a novel non-contact technique and modeled using a semi-empirical model developed by Dr.Chen. Adding more PET ratio to the blend, did not change beam profile of the transmitted beam significantly. Laser welding experiments were conducted in which joints were made while varying laser power and scanning speed. Measuring the weld strength and width showed that the blends containing PET have higher strength in comparison to pure PBT. The temperature-time profile at the interface during welding was predicted using a commercial FEM code. This information was combined with the degradation rate data to estimate the relative amount of degraded material at the weld interface. It showed that increasing the ratio of PET in the blend makes it more resistant against thermal degradation which can be one of the reasons the PET containing blends reach higher weld strengths when compared to pure PBT.en
dc.language.isoengen
dc.relation.ispartofseriesCanadian thesesen
dc.rightsThis publication is made available by the authority of the copyright owner solely for the purpose of private study and research and may not be copied or reproduced except as permitted by the copyright laws without written authority from the copyright owner.en
dc.subjectChemical Engineeringen
dc.subjectPolymeren
dc.subjectLaser Weldingen
dc.subjectPBT/PETen
dc.titleLaser Transmission Welding of Polybutylene Terephthalate and Polyethylene Terephthalate Blendsen
dc.typethesisen
dc.description.degreeM.A.Sc.en
dc.contributor.supervisorBates, Philip J.en
dc.contributor.supervisorZak, Geneen
dc.contributor.departmentChemical Engineeringen
dc.degree.grantorQueen's University at Kingstonen


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record