Queen's University - Utility Bar

QSpace at Queen's University >
Theses, Dissertations & Graduate Projects >
Queen's Theses & Dissertations >

Please use this identifier to cite or link to this item: http://hdl.handle.net/1974/1549

Title: Fabrication and Properties of Bi1/2Na1/2TiO3 Based Ferroelectric Ceramics with Low Levels of B-site Additives
Authors: McLaughlin, Shona Rae

Files in This Item:

File Description SizeFormat
McLaughlin_Shona_R_200810_PhD.pdf4.93 MBAdobe PDFView/Open
Keywords: Lead-free ferroelectric
perovskite
BNT
ceramics
Issue Date: 2008
Series/Report no.: Canadian theses
Abstract: Three different B-site additives, Mg1/3Nb2/3, Zr4+, and Cu1/2W1/2, were added to BNT ceramics in varying concentrations. These were abbreviated as BNMN, BNZ, and BNCW, respectively. The compositions were calcined to form a perovskite structure, ground to a fine powder, pressed into tablets and sintered to form dense ceramics. XRD analysis confirmed the formation of the perovskite phase. The electro-mechanical properties of the ceramics were evaluated. There were improvements in the low-field room temperature dielectric constant of 30% with 25% BNMN, 13% with 10% BNZ, and 16% with 2% BNCW. Higher concentrations of the additives degraded the dielectric performance. The conductivity of the BNT ceramics was reduced with very small concentrations (0.25 to 0.5%) of each of the additives. This reduction was maintained at the higher concentrations of the additives, which allowed for higher electric fields to be applied during both the poling process and the strain measurements. Improvements of approximately 30% in the d33 values were found at concentrations of 0.5% of each of the additives, but higher concentrations of the additives degraded the d33 values. The coercive field was affected by the additions to BNT. Increasing concentrations of BNMN reduced the coercive field in bipolar strain measurements. This was accompanied by a reduction in the remanent strain. Small additions (0.5 to 1.5%) of BNZ resulted in an increase in the coercive field by about 12%, followed by a 25% decrease at 5% BNZ. The remanent strain followed the same pattern. All concentrations of BNCW studied reduced the coercive field by about 12%. The remanent strain increased by 25% at 0.5% BNCW, and decreased by 42% at 2.5% BNCW. The electro-mechanical results for the BNMN and BNZ additives were compared to the behaviours of their lead-based counterparts, PMN and PZ. There was no consistent trend in the response of the electromechanical properties to the additions between the current lead-free and the lead-based systems.
Description: Thesis (Ph.D, Mechanical and Materials Engineering) -- Queen's University, 2008-10-03 15:13:24.791
URI: http://hdl.handle.net/1974/1549
Appears in Collections:Queen's Theses & Dissertations
Mechanical and Materials Engineering Graduate Theses

Items in QSpace are protected by copyright, with all rights reserved, unless otherwise indicated.

 

  DSpace Software Copyright © 2002-2008  The DSpace Foundation - TOP